Quimica Nova

In this work, the combustion process of ammonium dinitramide, ADN, has been modeled in two different situations: decomposition in open environment, with abundant air and decomposition in a rocket motor internal environmental conditions. The profiles of the two processes were achieved, based on molar fractions of the species that compose the products of ADN combustion. The velocity of formation and quantity of species in the open environment was bigger than the ones in the rocket motor environment, showing the effect of the different atmosphere in the reactions kinetics.

The objective of the current study was to develop and validate a simple, precise and accurate isocratic stability-indicating reversed-phase high-performance liquid chromatography (RP-HPLC) assay method for the determination of spironolactone and furosemide in solid pharmaceutical dosage forms. Isocratic RP-HPLC separation was achieved on an SGE 150 × 4.6 mm SS Wakosil II 5C8RS 5-μm column using a mobile phase of acetonitrile-ammonium acetate buffer (50:50, v/v) at a flow rate of 1.0 mL/min. The detection was carried out at 254 nm using a photodiode array detector. The drug was subject to oxidation, hydrolysis, photolysis and heat to apply stress conditions. The method was validated for specificity, linearity, precision, accuracy, robustness and solution stability. The method was found to be linear in the drug concentration range of 40-160 µg/mL with correlation coefficients of 0.9977 and 0.9953 for spironolactone and furosemide, respectively. The precision (relative standard deviation; RSD) among a six-sample preparation was 0.87% and 1.1% for spironolactone and furosemide, respectively. Repeatability and intermediate precision (RSD) among a six-sample preparation were 0.46% and 0.20% for spironolactone and furosemide, respectively. The accuracy (recovery) was between 98.05 and 100.17% and 99.07 and 100.58% for spironolactone and furosemide, respectively. Degradation products produced as a result of stress studies did not interfere with the detection of spironolactone and furosemide; therefore, the assay can be considered to be stability-indicating.

The increasing demand for fatty acid-free lecithin required modifications in existing purification methods. In this technical note we describe a purification procedure with the following steps: a) homogenization and extraction of yolks obtained from fresh eggs with acetone, b) solubilization with ethanol and solvent elimination and c) repeated solubilization/precipitation with petroleum ether/acetone. This crude extract was chromatographed on neutral alumina, which was exhaustively washed with chloroform before elution with chloroform:methanol, allowing the sequential separation of fatty acids and lecithin. Chromatographic behavior and mass spectra of the product are presented. This fast procedure yields fatty acid-free lecithin at a competitive cost.

This work presents an evolution profile of labels and containers of commercial chemicals employed in laboratories since 1870. Most chemicals were made in Germany before the Second World War, after which many other manufacturers arrived on the Brazilian market. North-american products were dominant in the 1940s, but Brazilian chemicals have increased their participation along time. Labels presented increasingly more information, from originally simple names of the compounds at the beginning of the XXth century to the data presented today such as chemical formulae, safety regards and detailed chemical analysis. The raw material for container manufacturing also changed: glass was dominant until the 1950s, but nowadays plastic flasks are preferred whenever possible. Cork covers were replaced by screw caps. The diversity of commercial products also sharply increased with time, especially after the 1950s, following the many new and specific applications of chemicals for research and commercial purposes.

Gravimetric and Bailey-Andrew methods are tedious and provide inflated results. Spectrofotometry is adequate for caffeine analysis but is lengthy. Gas chromatography also is applied to the caffeine analysis but derivatization is needed. High performance liquid chromatography with ultraviolet detection (HPLC-UV) and reversed phase is simple and rapid for xanthine multianalysis. In HPLC-UV-gel permeation, organic solvents are not used. HPLC-mass spectrometry provides an unequivocal structural identification of xanthines. Capillary electrophoresis is fast and the solvent consumption is smaller than in HPLC. Chemometric methods offer an effective means for chemical data handling in multivariate analysis. Infrared spectroscopy alone or associated with chemometries could predict the caffeine content in a very accurate form. Electroanalytical methods are considered of low cost and easy application in caffeine analysis.

GUIDE FOR CHROMATOGRAPHY COUPLED TO MASS SPECTROMETRY DATA PROCESSING. In this work, a discussed and step-wise tutorial for LC-MS and GC-MS data processing using the open-access software MZMine2 is presented and discussed. The rationale behind each step was demonstrated to enable the readers to go through their own data and process it accordingly. The main lesson to be learned is that each parameter must be chosen in light of the raw data and no guidelines should suggest a predetermined value. Still, it is worth mentioning that ideal values for each parameter do not exist, and that the user might end up investing too much time futilely optimizing values. Our suggestion is to process your data in light of the raw data (and the study design) following the preview figure result and the resulting feature list generated in each processing step, interpret your data, and go back to process it again to tune the detection of important features.