www.fgks.org   »   [go: up one dir, main page]
Skip to main content

Advertisement

SpringerLink
Log in

Cradle to gate environmental impact assessment of acrylic fiber manufacturing

  • LCA FOR MANUFACTURING AND NANOTECHNOLOGY
  • Published:
The International Journal of Life Cycle Assessment Aims and scope Submit manuscript

Abstract

Purpose

The aim of the current study was to analyze the impacts of acrylic fiber manufacturing on the environment and to obtain information for assisting decision makers in improving relevant environmental protection measures for green field investments in developing countries especially in Africa and Middle East and North Africa (MENA) regions. The key research questions were as follows: what are the different impacts of acrylic fiber manufacturing on the environment and which base material has the highest impact?

Methods

The life cycle assessment (LCA) started from obtaining the raw material until the end of the production process (cradle to gate analysis). Focus was given on water consumption, energy utilization in acrylic fiber production, and generated waste from the industry. The input and output data for life cycle inventory was collected from an acrylic fiber manufacturing plant in Egypt. SimaPro software was used to calculate the inventory of twelve impact categories that were taken into consideration, including global warming potential (GWP), acidification potential (AP), eutrophication potential (EP), carcinogen potential (CP), ecotoxicity potential (ETP), respiratory inorganic formation potential (RIFP), respiratory organic formation potential (ROFP), radiation potential (RP), ozone layer depletion (OLD), mineral depletion (MD), land use (LU), and fossil fuel depletion (FFD).

Results and discussion

LCA results of acrylic fiber manufacturing on the environment show that 82.0 % of the impact is on fossil fuel depletion due to the high-energy requirement for acrylonitrile production, 15.9 % of the impact is on human health, and 2.1 % on ecosystem quality. No impacts were detected on radiation potential, ozone layer depletion, land use, mineral depletion, or human respiratory system due to organic substances.

Conclusions

Based on these study results, it is concluded that acrylic fiber manufacturing is a high-energy consumption industry with the highest impact to be found on fossil fuel depletion and human health. This study is based on modeling the environmental effects of the production of 1-kg acrylic fiber and can serve to estimate impacts of similar manufacturing facilities and accordingly use these results as an indicator for better decision-making.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Subscribe and save

Springer+ Basic
EUR 32.99 /Month
  • Get 10 units per month
  • Download Article/Chapter or Ebook
  • 1 Unit = 1 Article or 1 Chapter
  • Cancel anytime
Subscribe now

Buy Now

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Fig 1
Fig 2
Fig 3

Similar content being viewed by others

References

  • World Acrylic Fibre (2013) World Acrylic Fibre—industry report: trend in demand and supply. Centerac Technologies Limited, India, p14–21

  • Ali AAM, Negm AM, Bady AF, Ibrahim AG (2014) Moving towards an Egyptian national life cycle inventory database. Int J Life Cycle Assess 19:1551–1558

    Article  Google Scholar 

  • Alonso JA, Camargo A (2006) Ecological and toxicological effects of inorganic nitrogen pollution in aquatic ecosystems: a global assessment. Environ Int 32:831–849

    Article  Google Scholar 

  • Babu Murugesh K, Selvadass M (2013) Life cycle assessment for the dyeing and finishing process of organic cotton knitted fabrics. JTATM 8(2):1–16

    Google Scholar 

  • Baker JW, Lepech M (2009) Treatment of uncertainties in life cycle assessment. Proceedings of the 10th international conference on structural safety and reliability, Osaka, Japan. September 13–17

  • Barber A, Pellow G (2006) LCA: New Zealand merino wool total energy use. 5th Australian Life Cycle Assessment Society (ALCAS) Conference, Melbourne, November 22–24

  • Barclay S, Buckley C (2000) Waste minimisation guide for the textile industry, a step towards cleaner production (volume 1), by the pollution research group, University of KwaZulu, Natal Durban - South Africa, January, 92 pp

  • Bengtsson J, Howard N (2010) A life cycle impact assessment. Part 1: classification and characterization. Building Products Innovation Council, Sydney NSW

    Google Scholar 

  • Beton A, Debora D, Laura F, Thomas G, Yannick L, Marie D, Anne P, Ines B, Oliver W, Jiannis K, Mauro C, Nicholas D (2014) JRC scientific and technical reports: Environmental improvement potential of textiles (IMPRO Textiles). European Commission Joint Research Center Institute for Prospective Technological Studies (IPTS), Seville - Spain. EUR Number: 26316 EN

  • BSR, Business for Social Responsability (2009) Apparel industry life cycle carbon mapping. Business for Social Responsability Network, USA

    Google Scholar 

  • CAPMAS (2015) Egypt in figures report 2015. Central agency for public mobilization and statistics, (March 2015). Published by central agency for public mobilization and statistics, Cairo - Egypt. Pp. 58

  • Collins M, Aumônier S (2002) Streamlined life cycle assessment of two Marks & Spencer plc apparel products. Environmental Resources Management, Oxford

    Google Scholar 

  • Dahllöf L (2004) Methodological issues in the LCA procedure for the textile sector: a case study concerning fabric for a sofa. Environmental Systems Analysis, Chalmers University of Technology, Göteborg

    Google Scholar 

  • El Raey M, Elsayed S, El-Hattab M, El Hadidi A (2007) Environmental impact assessment for acrylic fibers plant extension: ENVIRO-INFO consultants. Alexandria, Egypt

    Google Scholar 

  • Engelhardt AW (2013) World survey on textiles and nonwovens. Published by The Fiber Year GmbH Consulting, Speicher - Switzerland. Issue 13 Pp. 8

  • European Environment Agency (1997) Life-cycle assessment (LCA)—a guide to approaches, experiences and information sources. Copenhagen, Denmark

    Google Scholar 

  • Goedkoop M, Spriensma R (2000) Eco-indicator 99 methodology report. PRÃ Consultants, The Netherlands

    Google Scholar 

  • Goedkoop M, Schryver AD, Oele M (2008) Introduction to LCA with SimaPro 7. PRÃ Consultants, The Netherlands

    Google Scholar 

  • Gomes LS, Silva FA, Barbosasa S, Kummrow F (2012) Ecotoxicity of sludges generated by textile industries: a review. J Braz Soc Ecotoxicol 7:89–96

    Article  Google Scholar 

  • ISO14040 (2006) International Organization for Standardizations: Environmental management—life cycle assessment—principles and frameworks. Geneva, Switzerland

  • ISO14044 (2006) International Organization for Standardizations: Environmental management—life cycle assessment—requirements and guidelines. section 4.2.3.3. Published by International Organization for Standards, Geneva, Switzerland

  • Kalliala E, Nousiainen P (1999) Life cycle assessment—environmental profile of cotton and polyester-cotton fabrics. AUTEX Res J 1(1):8–20

    Google Scholar 

  • Kalliala E, Talvenmaa P (1999) Environmental profile of textile wet processing in Finland. J Clean Prod 8:143–154

    Article  Google Scholar 

  • Knackmuss HJ (1996) Basic knowledge and perspectives of bioelimination of xenobiotics compounds. J Biotechnol 51(3):287–295

    Article  CAS  Google Scholar 

  • Kolekar YM (2010) Isolation characterization and evaluation of dye degradation potential of the novel bacterial species Alishewanella soli. University of Pune, India. http://hdl.handle.net/10603/3221

  • Lai-Li W, Xue-mei D, Xiong-ying W (2009) The application of life cycle assessment in textile industry. Journal of Xi’an University Engineering Science and Technology 2:617–620

    Google Scholar 

  • Laing GI (1991) The impact of effluent regulations on the dyeing industry. Colouration 12:56–70

    Google Scholar 

  • Larsen SE, Hansen J, Knudsen HH, Wenzel H, Larsen HF, Møller KF (1997) Environmental assessment of textiles. Environmental Project No. 369, Danish Environmental Protection Agency, København -Denmark

  • Muthu SS, Li Y, Hu JY, Mok PY (2012) Quantification of environmental impact and ecological sustainability for textile fibres. Ecol Indic 13:66–74

    Article  CAS  Google Scholar 

  • Nieminen E (2003) Environmental indicators of textile products for ISO (Type III) environmental product declaration. AUTEX Res J 3:207–218

    Google Scholar 

  • Nieminen E, Linke M, Tobler M, Beke BV (2007) EU COST Action 628: life cycle assessment (LCA) of textile products, eco-efficiency and definition of best available technology (BAT) of textile processing. J Clean Prod 15(13–14):1259–1270

    Article  Google Scholar 

  • Ning X et al (2014) Levels, composition profiles and risk assessment of polycyclic aromatic hydrocarbons (PAHs) in sludge from ten textile dyeing plants. Environ Res 132:112–118

    Article  CAS  Google Scholar 

  • Pesnel S, Perwuelz A (2013) LCA: a decision-making tool for recycling processes in textile industry. The 6th international conference on life cycle management in Gothenburg. August 25–28

  • Pruden J (2012) Life cycle assessment of cotton fiber and fabric, executive summary. America’s Cotton Producers and Importers, USA

    Google Scholar 

  • Research and Markets (2011) Textiles: global industry guide. http://www.researchandmarkets.com/research/6eb45b/textiles_global_i

  • Sandin G, Petersb GM, Svanströmb M (2013) Moving down the cause-effect chain of water and land use impacts: an LCA case study of textile fibres. Resour Conserv Recycl 73:104–113

    Article  Google Scholar 

  • Shen L (2011) Bio-based and recycled polymers for cleaner production an assessment of plastics and fibres. Ph.D. thesis, Department of Science, Technology and Society (STS)/Copernicus Institute, Utrecht University

  • Shenai VV (2001) Non-ecofriendly textile chemicals and their probable substitutes—an overview. J Fiber Text Res 26:50–54

    CAS  Google Scholar 

  • Slokar YM, Marechal MAL (1998) Methods of decoloration of textile wastewaters. Dyes Pigments 37:335–356

    Article  CAS  Google Scholar 

  • Sule A (2012) Life cycle assessment of clothing process. Res J Chem Sci 2(2):87–89

    Google Scholar 

  • TEC (2010) Industry report. Acrylic in focus conference, 8–10 March 2010. Textile Export Council, Alexandria

    Google Scholar 

  • Tobler M (2000) Life cycle assessment of cotton fabrics in textile finishing. Paper presented at the Fiber Society Spring Conference 17–9 May, Sustainability and Recycling of Textile Materials, Guimaraes, Portugal, p 65

  • Tobler-Rohr MI (2011) Handbook of sustainable textile production, Woodhead Publishing Series in Textiles. Woodhead Publishing Limited, Cambridge

    Book  Google Scholar 

  • UNCTAD (2015) World investment report 2015: reforming international investment governance. United Nations Publication, United Nations, Geneva

    Google Scholar 

  • US.EPA, Environmental Protection Agency (1993) Air quality criteria for oxides of nitrogen. Volume I. National Service Center for Environmental Publications, Washington DC, USA, p 10–180

  • US.EPA, Environmental Protection Agency (2013) Toxicological review benzo[a]pyrene. National Service Center for Environmental Publications, Washington DC, USA, p 1–1

  • US.EPA, Environmental Protection Agency, Network TT (2011) Emissions factors & AP-42, CH 6: organic chemical process industry: 6.9 synthetic fibers, Washington, DC - USA. Pp:6.9-2-22

  • Van der Velden NM, Patel MK, Vogtländer JG (2014) LCA benchmarking study on textiles made of cotton, polyester, nylon, acrylic, or elastane. Int J Life Cycle Assess 19:331–356

    Article  CAS  Google Scholar 

  • Walser T, Demou E, Lang DJ, Hellweg S (2011) Prospective environmental life cycle assessment of nanosilver T-shirts. Environ Sci Technol 45(10):4570–4578

    Article  CAS  Google Scholar 

  • Yacout DMM, Abd El-Kawi MA, Hassouna MS (2014) Energy management applications in textile industry, case study: an Egyptian textile plant. Int Energy J 14(2):87–94

    Google Scholar 

Download references

Acknowledgments

Special thanks to both Dr. Abdelfattah Yacout and Dr. Abdellatif M. Yacout for their cooperation and support during manuscript preparation.

Author information

Authors and Affiliations

  1. Institute of Graduate Studies and Research, Alexandria University, Alexandria, Egypt

    Dalia M. M. Yacout, M. A. Abd El-Kawi & M. S. Hassouna

Authors
  1. Dalia M. M. Yacout
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. M. A. Abd El-Kawi
    View author publications

    You can also search for this author in PubMed Google Scholar

  3. M. S. Hassouna
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to Dalia M. M. Yacout.

Additional information

Responsible editor: Sonia Valdivia

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Yacout, D.M.M., Abd El-Kawi, M.A. & Hassouna, M.S. Cradle to gate environmental impact assessment of acrylic fiber manufacturing. Int J Life Cycle Assess 21, 326–336 (2016). https://doi.org/10.1007/s11367-015-1023-3

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s11367-015-1023-3

Keywords

Search

Navigation